Support : Labels
Our Tribeca Flip USB Flash Drive features a one-of-a-kind interchangeable label system. Here’s how to make the most of it.
LABEL TEMPLATES
Download and print your own replacement labels! All files are in PDF format. You will need Adobe Reader or a similar PDF viewer to open and print these files. Clicking the link(s) below will open the file in your default browser or PDF viewer. Right-click (control-click on Macintosh) to save the file to your computer instead.
HOW TO REPLACE LABELS
Your Flip Drive’s label is protected by a clear plastic cover that holds it in place and prevents smearing and scratching. The label slides in place through the opening between the upper and lower halves of the cover. View the narrow end of the cover head-on to find this opening, and then follow the directions below.
Method 1: Insert the tip of a mechanical pencil or an unbent paper clip in the small rectangular hole on the top of the cover, near the narrow end. Guide the old label out of the opening on the front of the cover until you can grasp it with your fingers. Slide your new label into the opening on the front of the cover.
Method 2: Insert your fingernail or a small, flat object (such as a metal ruler) into the opening on the front of the cover, and gently but firmly pry the upper half of the cover up. Four snaps hold the upper half in place; you may find it easier to undo two of the side snaps rather than both of the front snaps. Once the upper cover comes off, replace the label. Finally, snap the upper cover back in place.